• Get involved.
    We want your input!
    Apply for Membership and join the conversations about everything related to broadcasting.

    After we receive your registration, a moderator will review it. After your registration is approved, you will be permitted to post.
    If you use a disposable or false email address, your registration will be rejected.

    After your membership is approved, please take a minute to tell us a little bit about yourself.
    https://www.radiodiscussions.com/forums/introduce-yourself.1088/

    Thanks in advance and have fun!
    RadioDiscussions Administrators

Danagger plan b

J

jeff0201

New Participating Member
Does anyone out there have any specs on the power supply for a Danagger Plan B silence eliminator? I think the Plan B + uses the same supply.

It's a 5 pin DIN connector. Looking at the power supply board inside the unit, it looks like it would need 2 positive voltages and 1 negative voltage, with respect to ground. Maybe +- 12 or 15v, and +5v.
 
Most that use external power supplies, use off the shelf switching supplies available from Digikey or Newark Electronics. If you open the power supply case, you'll probably find a brand and model number of the supply itself. Many times the outputs are labeled too. Even sometimes Amazon sells replacement supplies.

Worst case is you'll have to de-solder and re-solder the cable leads on the replacement supply.
 
You must log in or register to reply here.
Status
This thread has been closed due to inactivity. You can create a new thread to discuss this topic.
Back
Top Bottom